Plasma cutting machine with a cutting tip how bad it is not easy? I believe this problem is that many users are quite concerned about the problem, in CNC plasma cutting machine in use, on the tip of the use of skills is directly related to cutting costs, an important factor, Guangzhou synthesis machinery following analysis of long-life use of plasma The key cutting machine cut lips.
1, cutting as little as possible perforation, perforation is a steel anti-splash will hurt the nozzle, which is cutting one of the major damage to the mouth, if you have to punch cutting, it is best to play at the perforation pre-drilled with a drill bit, from pre-drilled holes at the beginning of cutting;
2, as far as cutting machine rated normal cutting thickness range of cutting, try not to limit cutting depth on cutting domestic cutting machine of the normal cutting thickness is the manufacturer indicated maximum cutting thickness of 60% (cases of domestic 100A Plasma Cutter marked the largest manufacturers of cutting thickness of 32mm, but the normal cutting thickness 15-20mm), try to cut in the thickness range, the best protection you can cut the mouth;
3, cut mouth to keep a constant distance from the plate, usually in the 3-8mm or so, not only the power consumption too far away, cutting penetration power will decline, and relatively consumable electrode, the electrode life down; too close of that more simple, very cost nozzles, nozzle life will decrease exponentially, even with up incurs burned;
Of course, the nozzle of the plasma electrode life but also on some other factors, such as: the level of the input voltage, the electrode itself is quality, plasma cutting machines and equipment in good condition on the quality of the degree of plasma torch on the quality of the user experience, etc., but most of the above three points, three points better, then pay attention to the life of the electrode nozzle will greatly improve.
Cathy 
Cathy
sales@gzhch.com
